| |
Mounting alternatives
All door gates can be
installed in the casing of the door or on the face of the opening. Mounting on the face of the opening will leave the door
opening unobstructed by the gate or the locking bar.
Also the gates can be installed on the left or the right side of the door.
Simply turn the gate upside down to mount on the opposite side.
|
| |
| Installation Steps: |
1. Stand folded gate against
the doorframe where you intend to mount
it.
 |
2. Mark the mounting surface
through the holes in the hinge bar with
a
pen or pencil.
For mounting into:
Wood: use 5/16 x 1-1/2" Lag Screws
Brick or Concrete: use 5/16 x 1-1/2" Lag Screws inserted in to 5/16" short
lag shields that have been pushed into 1/2" holes
Steel: drill and tap for 5/16 x 1" Bolts
Installations kits, including lag screws, lag shields and padlocks are
available, contact Customer Service at Security Gate Co.
|
3. Drill appropriate size holes
in the mounting surface.
 |
4. Mount the gate by inserting
the screws through the hinge bar.
 |
5. Stretch the gate across the
opening. Line up the locking bar on the
opposite side so that the padlock hole in
the gate and the padlock hole in the locking
bar match
 |
6. Mark through the mounting
holes of the locking bar with a pen or pencil.
 |
| 7. Drill holes and insert the
screws to mount the locking bar. |
8. Pull the door into the locking
bar, and insert a padlock.
|
